I work at a Hobie Dealer and we always install the pulleys right along the line where the deck of the boat meets the hull.
hope this helps
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Revo anchor trolley http://www.hobie.com/au/en/forums/viewtopic.php?f=26&t=21236 |
Page 1 of 1 |
| Author: | FishIt [ Thu Feb 18, 2010 10:01 am ] |
| Post subject: | Revo anchor trolley |
Recently got a new Revolution... Haven't had it in the water yet but want to get it rigged and ready. Common sense tells me that the pulleys for the anchor trolley should be above the waterline but since I don't know just where the waterline will be (with a load of about 250 pounds) can anyone offer a suggestion regarding how far above or below the hull seam they should go, based on their experience? Any suggestions will be greatly appreciated. |
|
| Author: | S.Yoars [ Thu Feb 18, 2010 6:57 pm ] |
| Post subject: | Re: Revo anchor trolley |
I work at a Hobie Dealer and we always install the pulleys right along the line where the deck of the boat meets the hull. hope this helps
|
|
| Author: | sunjammers [ Thu Feb 18, 2010 7:11 pm ] |
| Post subject: | Re: Revo anchor trolley |
You want them as low as possible w/o them sticking out past the edge of the hull. You want to be able to slide down a pylon w/o them catching! |
|
| Author: | Gurkman [ Sat Feb 20, 2010 10:37 am ] |
| Post subject: | Re: Revo anchor trolley |
Believe it or not, there is actually a tutorial on how to mount it on YouTube by KayakFishNation. http://www.youtube.com/watch?v=Q2x5JRdQvmI |
|
| Author: | FishIt [ Mon Feb 22, 2010 10:59 am ] |
| Post subject: | Re: Revo anchor trolley |
Helpful tips and much appreciated... I installed the trolley before I saw the YouTube clip, and got it basically correct! Thanks!
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|