| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| transducer gap. http://www.hobie.com/au/en/forums/viewtopic.php?f=26&t=57947 |
Page 1 of 1 |
| Author: | Al. [ Sun Jun 12, 2016 10:04 am ] |
| Post subject: | transducer gap. |
I'm about to mount a lowrance transducer into my Revo 13, but I have found conflicting information regarding installation gaps. In one video they say leave a 2mm gap, but another mounts it tight to the lowrance ready plate. Which is correct and does it really make a difference. 
|
|
| Author: | Dr.SteelheadCatcher [ Sun Jun 12, 2016 8:23 pm ] |
| Post subject: | Re: transducer gap. |
If you have the "Lowrance ready hull", then a 2-3mm gap between the transducer and cover plate fills in with water, to better conduct the sonar wave through the water. |
|
| Author: | HStrech [ Wed Jun 29, 2016 3:26 pm ] |
| Post subject: | Re: transducer gap. |
We recommend leaving a small gap between the bottom of the transducer and the Lowrance ready plate. |
|
| Author: | JohnsYak [ Wed Jun 29, 2016 7:52 pm ] |
| Post subject: | Re: transducer gap. |
I just installed mine, and there was a small natural gap after seating the transducer in the housing. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|