Great info. Thanks Roy.
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Old MD Cam Lock conversion to Click-N-Go, best way IMHO... http://www.hobie.com/au/en/forums/viewtopic.php?f=26&t=67412 |
Page 1 of 1 |
| Author: | niswanger [ Sun Sep 20, 2020 5:56 pm ] |
| Post subject: | Old MD Cam Lock conversion to Click-N-Go, best way IMHO... |
Almost gave up on my 2008 Revo...I really beat this kayak to death, each successive repair on the cam lock area resulted in faster and faster failure afterwards. After a major struggle coming into a gulf to inland water-way channel a few months back during a strong outgoing tide, I think it was the last straw for this great little kayak, until now. Here's how I used after-market Click-N-Go mechanisms to replace the old cam locks. I did a major modification to the mechanism, check it out: Field test today, before permanently securing with Loctite 3035 went well too: -Roy |
|
| Author: | niswanger [ Thu Sep 24, 2020 9:49 am ] |
| Post subject: | Re: Old MD Cam Lock conversion to Click-N-Go, best way IMHO. |
Final and permanent install: |
|
| Author: | Roadrunner [ Thu Sep 24, 2020 8:50 pm ] |
| Post subject: | Re: Old MD Cam Lock conversion to Click-N-Go, best way IMHO. |
Great info. Thanks Roy.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|