| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Retrofit for GlideTech Roller Bearings http://www.hobie.com/au/en/forums/viewtopic.php?f=26&t=72244 |
Page 1 of 1 |
| Author: | mattyoga [ Sun Mar 08, 2026 7:24 pm ] |
| Post subject: | Retrofit for GlideTech Roller Bearings |
Hi all, One of my mirage drive glide tech sprockets has become very chewed up from a mix of sand and grease as have the matching roller bearings. I'm considering looking at puttin a sleeve of PTFE tubing over the sprocket shaft to replace the bearings (sleeve would be slightly smaller than diameter of bearing) as I cannot source a sprocket here in Oz as present. This would be a sort of downgrade back to pre glidetech days. Would be interested to here if anyone has tried this or similar or if there are any reasons why this is a bad idea. Cheers Matt |
|
| Author: | CallahanReed [ Mon Mar 16, 2026 12:20 am ] |
| Post subject: | Re: Retrofit for GlideTech Roller Bearings |
Same here. Bump |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|