| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| MOLDED IN ROD HOLDERS DIFFERENT DEPTH http://www.hobie.com/au/en/forums/viewtopic.php?f=26&t=9515 |
Page 1 of 1 |
| Author: | aztxrogue [ Mon May 26, 2008 5:35 pm ] |
| Post subject: | MOLDED IN ROD HOLDERS DIFFERENT DEPTH |
I just bought a pair of hobie rod holder extensions, and while putting them in noticed the depth of the rod holders on my revo have different depths, the right side is much shallower, a/nd has a much poorer fit than the left side, has any one else noticed this |
|
| Author: | Revolutionary [ Thu Jun 12, 2008 9:11 pm ] |
| Post subject: | Rod Holders Different Lengths |
Did you possibly buy a demo? I noticed that the demo Revolution at my local dealer had the same problem but was clearly marked demo. Have you talked to your dealer about the problem? Given a chance, I bet they will do their best to correct the problem. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|