| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Harken 8:1 Main Sheet http://www.hobie.com/au/en/forums/viewtopic.php?f=34&t=10657 |
Page 1 of 1 |
| Author: | mddmx [ Mon Sep 08, 2008 12:53 pm ] |
| Post subject: | Harken 8:1 Main Sheet |
This may be old news to most of you guys, but I just installed the greatest new accessory for the H20 .... HARKEN 57mm CARBO RATCHAMATIC 8:1 LOW-PROFILE MAINSHEET SYSTEM from murrays.com It makes a huge difference. When the hull would come up, and I uncleat, I used to really fight that 6:1 .... now it's easy and I feel a lot more in control, as I can make much smaller changes without spoiling the thrill of the ride. This really should have been standard equipment on this ride. |
|
| Author: | srm [ Mon Sep 08, 2008 1:46 pm ] |
| Post subject: | |
Just an FYI, you're old mainsheet system was most likely a 7:1 since that was stock on the 20. Even so, the 7:1 takes a strong pull, and if you were actually 6:1, that would be a whole lot of pull. Also, 7:1 is the max allowed by the class rules. sm |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|