| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rudder Cam replace http://www.hobie.com/au/en/forums/viewtopic.php?f=34&t=4978 |
Page 1 of 1 |
| Author: | knut [ Sun Sep 24, 2006 1:20 pm ] |
| Post subject: | Rudder Cam replace |
I have just replaced the broken rudder cams on the 20. But with the new cams the rudder don't lock anymore down (it seem to be to thight). Any advice??? |
|
| Author: | hobie1616 [ Sun Sep 24, 2006 4:20 pm ] |
| Post subject: | |
Adjust the spring tension on the plunger that holds the cam in the up or down position by rotating the tension screw in the bottom of the lower casting. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|