| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Rudder arm orientation http://www.hobie.com/au/en/forums/viewtopic.php?f=34&t=56335 |
Page 1 of 1 |
| Author: | rmjr [ Wed Oct 28, 2015 12:22 pm ] |
| Post subject: | Rudder arm orientation |
I have always had the rudder arms facing inward. I was working on the 20 rudders and noticed the upper castings are stamped L & R, but if you put them on designated side, they point outward. Which is the proper way? |
|
| Author: | rmjr [ Wed Oct 28, 2015 4:42 pm ] |
| Post subject: | Re: Rudder arm orientation |
Should have googled before I posted, The casting are stamped wrong |
|
| Author: | srm [ Thu Oct 29, 2015 4:59 am ] |
| Post subject: | Re: Rudder arm orientation |
They should definitely point inward. sm |
|
| Author: | mmiller [ Thu Oct 29, 2015 10:20 am ] |
| Post subject: | Re: Rudder arm orientation |
The stamp was for the molder apparently, not to show left vs right in use. Pretty silly that they didn't mark them for proper use though. This issue comes up again and again. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|