| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| hobie 20 mast working drawings http://www.hobie.com/au/en/forums/viewtopic.php?f=34&t=6890 |
Page 1 of 1 |
| Author: | benskiing [ Fri Jun 01, 2007 11:16 am ] |
| Post subject: | hobie 20 mast working drawings |
I am ready to rivet all my 20 parts on my new extrusion. And my old mast is bent like a wet noodle. I am looking for the drill distances up the mast. especially the diamond wire points and upper diamond wire mounts. Also the cut length for a hobie 20 mast prior to comptip installation. The donor mast is a h18 all alluminum extrusion. Can anyone email me working drawings. or specs? thanks ben [email protected] |
|
| Author: | mmiller [ Fri Jun 08, 2007 9:41 am ] |
| Post subject: | Drawings |
Unfortunately drawings are not available for distribution from Hobie Cat. You would have to take the measurements off your old mast. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|