| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Daggerboard cord http://www.hobie.com/au/en/forums/viewtopic.php?f=37&t=32944 |
Page 1 of 1 |
| Author: | KennyB [ Mon Nov 01, 2010 10:04 am ] |
| Post subject: | Daggerboard cord |
Where can I buy some of the line/shock cord that holds my daggers up? |
|
| Author: | mmiller [ Mon Nov 01, 2010 1:22 pm ] |
| Post subject: | Re: Daggerboard cord |
Dealer? Should be 1/4" shock cord. |
|
| Author: | KennyB [ Mon Nov 01, 2010 2:30 pm ] |
| Post subject: | Re: Daggerboard cord |
Hey Matt...looks like mine is at least 1/2" shock cord, but it has a rope sleeve over it. My Tiger is a 2004 model. |
|
| Author: | mmiller [ Mon Nov 01, 2010 4:13 pm ] |
| Post subject: | Re: Daggerboard cord |
The roller style shock cord was more like 3/8", but Jacques recommends the current style (Squeegee) system F99501200 DAGGERBOARD HOLD DOWN KIT ($19.15 USD 11/2010) |
|
| Author: | KennyB [ Mon Nov 01, 2010 4:34 pm ] |
| Post subject: | Re: Daggerboard cord |
K...I can do that...thanks! |
|
| Author: | Sparky-Marky [ Mon Nov 08, 2010 7:13 am ] |
| Post subject: | Re: Daggerboard cord |
I dont know about everyone else but my boards are near impossible to raise if there is any side force on them. I assume you only use the cord whilst going through a tack or gybe or when side loading is low? What system is everyone using to keep your boards up? If your using a cord to pull them up can that same cord be used to keep them up? I am very intressed in fitting some of these, it is often very annoying having to send the crew to leward to raise boards. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|