| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Anchor pins http://www.hobie.com/au/en/forums/viewtopic.php?f=37&t=33651 |
Page 1 of 1 |
| Author: | ryan.120 [ Thu Jan 13, 2011 8:16 am ] |
| Post subject: | Anchor pins |
hello everyone just a quick question about the anchor pins for the shrouds on my tiger they have moved out of place and am wondering what holds them in place and do i have take them out to sort the problem out thet feel like there is a threaded part on the pin but do not know if its into a threaded plate or not any help would be great thanks paudie |
|
| Author: | Karl Brogger [ Thu Jan 13, 2011 1:43 pm ] |
| Post subject: | Re: Anchor pins |
The pin threads into the hull. I'm not sure what they thread into, if its a plate or a plug of sorts. If the threads are messed up on the female part I'm not sure what you can do other than run a tap in it and clean up what is left. Or, cut out whatever it threads into and replace it. |
|
| Author: | hobie18rich [ Fri Jan 14, 2011 1:21 pm ] |
| Post subject: | Re: Anchor pins |
On the Tigers there is a plate glassed into the hull. Accessable from the front port hole cover. the pin screws through the plate. I will try to get a decent pic. |
|
| Author: | ryan.120 [ Fri Jan 14, 2011 6:12 pm ] |
| Post subject: | Re: Anchor pins |
Thanks for your help guys can not get a good look at it inside the hull will thread them back into the hull and see what happen paudie |
|
| Author: | hobie18rich [ Fri Jan 14, 2011 11:55 pm ] |
| Post subject: | Re: Anchor pins |
make sure to put some Sika Flex on the bolt oand in the hole before you thread it in. keeps it water tight. |
|
| Author: | KennyB [ Sun Jan 16, 2011 6:58 am ] |
| Post subject: | Re: Anchor pins |
Get one of those small teloscopic mirrors at an automotive parts store...should be able to see the plate then. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|