| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hull repair question http://www.hobie.com/au/en/forums/viewtopic.php?f=37&t=4804 |
Page 1 of 1 |
| Author: | Thunt [ Tue Sep 05, 2006 2:19 pm ] |
| Post subject: | Hull repair question |
I recently noticed a thin vertical crack along the very front edge (bow) of the hull(both)where the hull is joined together. Has anyone encountered this? I am probably going to sand off the gel coat to see how deep the crack runs, although I can't believe it goes through to the interior. I have not hit anything so I am assuming it is a natural seam crack. Any help would be appreciated. Thanks Thomas |
|
| Author: | mmiller [ Wed Sep 13, 2006 11:05 am ] |
| Post subject: | Tiger hulls |
Replied under "help with repairs" The Tiger hulls are "Clam shell" two halfs joined down the center of the deck / keel / bow, so a visable "crack" may be crazing over a bit of flex the hull went through. The gel coat could be thin maybe. Photo? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|