| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mast Keeper knob drill angle http://www.hobie.com/au/en/forums/viewtopic.php?f=42&t=25882 |
Page 1 of 1 |
| Author: | kylasu [ Thu Jun 03, 2010 10:36 am ] |
| Post subject: | Mast Keeper knob drill angle |
The mast keeper knob and screw on my 2008 Bravo is drilled at the wrong angle making it very difficult to attach the hinge gate without using a lot of force to push the mast into the A frame. I just bought this Bravo used and after having so much trouble getting it in, checked a friends Bravo and saw the difference in angle and tightness when set up. Anyone have an idea on how to fix this, or am I just stuck with a difficult assembly or ordering a new A frame. |
|
| Author: | mmiller [ Thu Jun 03, 2010 10:56 am ] |
| Post subject: | Re: Mast Keeper knob drill angle |
You can try tweaking the A frame for better alignment with the bearing collar. It may be a little bent. 2010 models use a new gate design to help with tight tolerances at this connection. We do not have this as a simple replacement part. The A frame would have to be replaced. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|