Hobie Forums
http://www.hobie.com/au/en/forums/

Bravo slippery sitting
http://www.hobie.com/au/en/forums/viewtopic.php?f=42&t=60476
Page 1 of 1

Author:  rbrower [ Sat May 06, 2017 7:32 am ]
Post subject:  Bravo slippery sitting

Often times sailing the Bravo I find my body "slipping" back towards the stern....even though I use the foot straps. Has anyone applied any non-slip type material to the top of each hull (rear portion) to prevent this slippage? Any ideas/suggestions would be welcome and greatly appreciated....including the best materials and adhesive for this purpose. I was thinking of possibly using the Wave blue seat material.

Author:  Norm742 [ Sat May 06, 2017 7:01 pm ]
Post subject:  Re: Bravo slippery sitting

Check out tradisrad's solution here: https://www.hobie.com/forums/viewtopic.php?f=24&t=57337

Author:  Matt15 [ Sun May 14, 2017 3:02 am ]
Post subject:  Re: Bravo slippery sitting

I've never considered the slipping to be that much of an issue until recently flying downwind whilst hanging on for dear life. I might consider doing something similar. I would look at using some closed cell EVA foam - same stuff they use on SUPS and surf boards. It's everywhere these days, in loads of colours and relatively cheap.

Author:  rbrower [ Fri May 26, 2017 1:51 pm ]
Post subject:  Re: Bravo slippery sitting

Purchased some closes EVA cell foam from Agenda Surf. Worked out very well just make sure you order the adhesive for "plastic". I would post a picture but I cannot figure out how to....

Author:  buxton [ Wed Jun 14, 2017 4:45 am ]
Post subject:  Re: Bravo slippery sitting

I've used a H16 rail kit to upgrade my Bravo and T2, works really great. I don't have a photo of my Bravo but here is my T2.
Image

Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/