Noticed this split on the top rudder mount on the Bravo, doesn’t look like it goes through, is this normal around the rudder pin mount? Anything to worry about, do I need to get the plastic welder?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Crack at rudder pin http://www.hobie.com/au/en/forums/viewtopic.php?f=42&t=66668 |
Page 1 of 1 |
| Author: | Brianm [ Sun Jun 07, 2020 5:50 pm ] |
| Post subject: | Crack at rudder pin |
Noticed this split on the top rudder mount on the Bravo, doesn’t look like it goes through, is this normal around the rudder pin mount? Anything to worry about, do I need to get the plastic welder?
|
|
| Author: | mmiller [ Mon Jun 08, 2020 8:59 am ] |
| Post subject: | Re: Crack at rudder pin |
You might be able to weld it. Keep an eye on it that does not look good. |
|
| Author: | [email protected] [ Mon Jan 02, 2023 2:44 pm ] |
| Post subject: | Re: Crack at rudder pin |
I have exactly the same crack on my Bravo. How do I fix this? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|