Hobie Forums http://www.hobie.com/au/en/forums/ |
|
Hobie Bravo Gate Assembly Bolt Spacer? loose http://www.hobie.com/au/en/forums/viewtopic.php?f=42&t=67893 |
Page 1 of 1 |
Author: | Rabbitmat [ Sat Feb 13, 2021 12:36 am ] |
Post subject: | Hobie Bravo Gate Assembly Bolt Spacer? loose |
Hello I am having an issue whereby the small round spacer on the gate assembly bolt that goes through the a-frame is unwinding itself. I can only assume this spacer was originally loctite fitted and has come loose. It must be just hitting the inside of the a-frame. Am I right in supposing this spacer is only there to stop the bolt from falling out of the a-frame when undone? I tried to wind it back in as far as possible back into the a-frame but it is now loose and every time I unwind the mast assembly bolt to remove the mast it seems to again unwind. Should I remove or try to loctite again? To do this do I need to remove the knob at the other end of the bolt and pull through? I also suspect this may be loctite fitted and may be difficult. Boat is only 1 year old. Thanks |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |