Hobie Forums http://www.hobie.com/au/en/forums/ |
|
Dent in hull http://www.hobie.com/au/en/forums/viewtopic.php?f=42&t=68973 |
Page 1 of 1 |
Author: | BillFollyBeach [ Thu Aug 26, 2021 4:44 am ] |
Post subject: | Dent in hull |
I have a Wave and considering buying a Bravo. I was all good with buying it until the seller told me that the Bravo has been sitting against a trailer fender and it has left a dent in one of the hulls. The Bravo is located in SE USA and has been sitting in the heat I assume. The seller is confident that they dent will come out naturally over time, is that true? |
Author: | mmiller [ Thu Aug 26, 2021 8:11 am ] |
Post subject: | Re: Dent in hull |
It might... https://www.hobie.com/forums/viewtopic.php?f=21&t=35313 |
Author: | BillFollyBeach [ Thu Aug 26, 2021 8:32 am ] |
Post subject: | Re: Dent in hull |
Hi Matt: I am not sure the thickness of a Bravo's hull compared to that kayak in the video but I am assuming the Bravo is thicker? Is that rotomold of the kayak the same type of rotomold as the Bravo? I guess you using the word "might" should scare me. Thanks for your time. |
Author: | mmiller [ Thu Aug 26, 2021 8:53 am ] |
Post subject: | Re: Dent in hull |
Maybe a little thicker. Same material and process as a Kayak. |
Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |