| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Let me see your righting pole! http://www.hobie.com/au/en/forums/viewtopic.php?f=45&t=35871 |
Page 1 of 1 |
| Author: | jack swift [ Mon May 30, 2011 12:18 pm ] |
| Post subject: | Let me see your righting pole! |
I'm putting mine on this week and I'd like to see what works and what doesn't. BIG pictures please! I'm thinking 1 1/8" 1/8" wall 10-11' long supported by 3 main guy-wires ( 1 at each end of the dolphin striker, and 1 to the rear crossbar.) attached 8-9' and another pair (again to the far ends of the dolphin striker blade) about mid way up to prevent bowing. may go a entirely different way, dunno still open to ideas. |
|
| Author: | spesce [ Tue May 31, 2011 9:18 pm ] |
| Post subject: | Re: Let me see your righting pole! |
Here is mine. http://www.hobiecat.com/forums/viewtopic.php?f=45&t=14627 Still untested, but I believe it will work great! Here is a video righting a 21SE. Still looks difficult.http://www.youtube.com/watch?v=4adNW6tSk8A I have the gopro and will record its use when it comes about. |
|
| Author: | BrianCT [ Sat Jun 04, 2011 6:12 am ] |
| Post subject: | Re: Let me see your righting pole! |
Here's a pole I just built for my H18. It's similar in design to the "Solo Right" you can see in use on Youtube, only I'm using square aluminum tubing instead of an oar. (Note: I have yet to install the support lines)..... http://www.hobiecat.com/forums/viewtopic.php?f=13&t=35586 |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|