| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| New mast base - pin not fitting past ball http://www.hobie.com/au/en/forums/viewtopic.php?f=45&t=65684 |
Page 1 of 1 |
| Author: | SRQ21SC [ Tue Oct 15, 2019 3:50 pm ] |
| Post subject: | New mast base - pin not fitting past ball |
Hey guys, The mast base on my 21sc had a piece sheared off by previous owner and I replaced it with the correct part ( 36641031). However, when inserting the pin now to hold the mast base to the ball, it will not fit past the ball. Anyone run into this? |
|
| Author: | mmiller [ Thu Oct 17, 2019 9:02 am ] |
| Post subject: | Re: New mast base - pin not fitting past ball |
Damaged ball or miss-aligned hole / bent pin? You can drill the hole a bit larger. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|