| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Recommended way to remove pads from hull? http://www.hobie.com/au/en/forums/viewtopic.php?f=47&t=13029 |
Page 1 of 1 |
| Author: | sneakypete [ Thu Jul 09, 2009 10:55 am ] |
| Post subject: | Recommended way to remove pads from hull? |
I have a jam cleat that cracked (operator error?) and I'm wondering if there is a good way to get these glued-on parts free from the hull so a replacement can be made. Please share your favorite tips. Thanks! |
|
| Author: | mmiller [ Thu Jul 09, 2009 2:51 pm ] |
| Post subject: | Re: Recommended way to remove pads from hull? |
I have emailed our engineers to respond, but it may not be till next week, so... As I recall, you grind off the plastic and vinyl. I think they used a dremmel. |
|
| Author: | sneakypete [ Thu Jul 09, 2009 4:07 pm ] |
| Post subject: | Re: Recommended way to remove pads from hull? |
Thanks Matt! I'm quite sure this can wait till next week. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|