I'm looking for a part number for the i-series rudder control that mounts on the side of the Vantage seat...I need to order an extra one for a project I'm working on...cheers, roger
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| i-series rudder control http://www.hobie.com/au/en/forums/viewtopic.php?f=47&t=60518 |
Page 1 of 1 |
| Author: | rogerdodger [ Thu May 11, 2017 2:34 pm ] |
| Post subject: | i-series rudder control |
I'm looking for a part number for the i-series rudder control that mounts on the side of the Vantage seat...I need to order an extra one for a project I'm working on...cheers, roger
|
|
| Author: | Jbernier [ Thu May 11, 2017 3:30 pm ] |
| Post subject: | Re: i-series rudder control |
rogerdodger wrote: I'm looking for a part number for the i-series rudder control that mounts on the side of the Vantage seat...I need to order an extra one for a project I'm working on...cheers, roger Those are part number 84501401 (this is the base number they're $9.19) any dealer can obtain this item for you. |
|
| Author: | rogerdodger [ Thu May 11, 2017 5:21 pm ] |
| Post subject: | Re: i-series rudder control |
Jbernier wrote: rogerdodger wrote: I'm looking for a part number for the i-series rudder control that mounts on the side of the Vantage seat...I need to order an extra one for a project I'm working on...cheers, roger Those are part number 84501401 (this is the base number they're $9.19) any dealer can obtain this item for you. thanks, is that just the steering handle? I am looking for the round rudder control unit for an i-series that mounts on the side of the Vantage seat...I sure hope it's only $9...lol |
|
| Author: | mmiller [ Thu May 11, 2017 5:36 pm ] |
| Post subject: | Re: i-series rudder control |
This is just the bottom round part with slots on the bottom and two small pulleys. |
|
| Author: | rogerdodger [ Thu May 11, 2017 6:22 pm ] |
| Post subject: | Re: i-series rudder control |
mmiller wrote: This is just the bottom round part with slots on the bottom and two small pulleys. great, that sounds like what I'm looking for. thanks. |
|
| Author: | scrub [ Sat Jun 09, 2018 6:59 am ] |
| Post subject: | Re: i-series rudder control |
Glad to see this post. The base of my rudder control (the thin plastic bridge) broke at the front of the mounting channel. This is a very fragile design. The base should be made of cast aluminum or the channel mount should be completely redesigned to make it much stronger. |
|
| Author: | mcs624 [ Sun Jan 17, 2021 11:18 am ] |
| Post subject: | Re: i-series rudder control |
I just had to replace my lower housing as well. It cracked where it slides over the bracket on the side of the seat. This really should be made out of a stronger material! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|