| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 180 fin failure http://www.hobie.com/au/en/forums/viewtopic.php?f=47&t=61397 |
Page 1 of 1 |
| Author: | tomswell [ Sun Aug 27, 2017 6:47 am ] |
| Post subject: | 180 fin failure |
I just launched new i14T for the third time ever in a remote lake to have one blade tab break allowing the fin to disappear. This was disappointing for sure. Even more disappointing is that I called several dealers in Idaho and Montana and apparently no one has replacement fins for 180 drives. Can a V2 fin be used as a bandaid? What's the best web source for a possible UPS blue label will call order? IS THIS AN ENGINEERING FAULT? Is this a typical fin fault with V2 drives? |
|
| Author: | Defy [ Mon Aug 28, 2017 4:16 pm ] |
| Post subject: | Re: 180 fin failure |
I notice mine separating a little but i still have lots of warranty so i am not stressing yet. And its really not that much but one fin does look different. Sent from my iPhone using Tapatalk |
|
| Author: | mmiller [ Tue Sep 05, 2017 12:25 pm ] |
| Post subject: | Re: 180 fin failure |
That would be covered by warranty and through warranty... the parts are available. Make a claim with your dealer. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|