| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| i12s Rudder Control Cable snapped from the rudder http://www.hobie.com/au/en/forums/viewtopic.php?f=47&t=66826 |
Page 1 of 1 |
| Author: | SuperVehicle001 [ Mon Jun 29, 2020 10:15 pm ] |
| Post subject: | i12s Rudder Control Cable snapped from the rudder |
The nylon rudder control cable frayed and snapped and is now so far up the rudder control tube housing I can't get it back out to tie it back on. How am I supposed to thread a new nylon cable through this thing? It should be a super simple repair yet there is no way to get the cable through the tubing! |
|
| Author: | mmiller [ Tue Jun 30, 2020 12:17 pm ] |
| Post subject: | Re: i12s Rudder Control Cable snapped from the rudder |
You can push the new line through from the front end. That or a piano wire fed through and pull. |
|
| Author: | SuperVehicle001 [ Tue Jun 30, 2020 6:32 pm ] |
| Post subject: | Re: i12s Rudder Control Cable snapped from the rudder |
mmiller wrote: You can push the new line through from the front end. That or a piano wire fed through and pull. What part number is the new line? I can't seem to find it. Also how thin of wire do I need? Will any piano wire do? |
|
| Author: | mmiller [ Thu Jul 02, 2020 9:16 am ] |
| Post subject: | Re: i12s Rudder Control Cable snapped from the rudder |
Part number 81054. By the foot. I am told that this line can be pushed through. Not sure on the wire type. Thin of course! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|