Hobie Forums http://www.hobie.com/au/en/forums/
control lines http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=18373	Page 1 of 1

---

Author:	dpstivers [ Sat Dec 19, 2009 4:48 pm ]
Post subject:	control lines
how do you keep your main sheet and furling lines where you need them? Mine end up where I can't reach them, over-board or tangled up in the mirage drive.

---

Author:	Joseph Thompson [ Sun Dec 20, 2009 10:46 am ]
Post subject:	Re: control lines
A good start is to tie the ends of the furling line and mainsheet together. Keeps them in reach, and mostly where you want 'em.

---

Author:	rokraider [ Sun Dec 20, 2009 11:15 am ]
Post subject:	Re: control lines
I have fitted a longer furling line and run it through an eye I have mounted over the rudder downhaul and simply tie a knot in the end of it. This keeps it within easy reach. I have fitted a caribiner to the eye that you run the dagger board elastic through and run the mainsheet through the caribiner with a knot in the end. Again, always within easy reach.

---

Author:	KayakingBob [ Sun Dec 20, 2009 1:01 pm ]
Post subject:	Re: control lines
Like Joseph Thompson said: A permanent loop in the sheet line, to tie the reefing line to. Also, used to keep the lines tight during transport:

---

Page 1 of 1	All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/