Hobie Forums
http://www.hobie.com/au/en/forums/

what is the depth of the TI Hull?
http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=31571		 Page 1 of 1
Author:  myht [ Sun Sep 12, 2010 9:37 am ]
Post subject:  what is the depth of the TI Hull?
I can't seem to find published dimensions for the depth of the TI hull. I see width, height, weight, etc. but not the depth. Can someone help me out with this?

thanks,
Author:  stringy [ Sun Sep 12, 2010 3:58 pm ]
Post subject:  Re: what is the depth of the TI Hull?
About 45cm from the bottom of the hull to the top cams on the forward crossbar.
Author:  Paul67 [ Mon Sep 13, 2010 4:26 am ]
Post subject:  Re: what is the depth of the TI Hull?
45cm is that all?
It look a a lot more than that in the pics; interesting!
Author:  whosyerbob [ Mon Sep 13, 2010 1:18 pm ]
Post subject:  Re: what is the depth of the TI Hull?
The depth of the TI depends on the crew weight, the maximum weight of the gear stowed aboard, and the conditions outside.

We regularly go into areas where it's much less than 12 inches deep - we have to pull up the Mirage drives, the centerboard and rudder - and end up steering with a straight paddle. :D
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/