| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| trailers http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=40522 |
Page 1 of 1 |
| Author: | kayakman7 [ Mon Dec 05, 2011 3:44 pm ] |
| Post subject: | trailers |
hey, I was just wondering how much people were paying for their trailers? I paid $125 for a used galvanized trailer that I then customized for the TI. With cradles at $220 and some hardware, I spent under $400 and it is still light enough to push around. cheers, jesse |
|
| Author: | Tom Kirkman [ Mon Dec 05, 2011 6:04 pm ] |
| Post subject: | Re: trailers |
I've bought two trailers recently - both are used but like new. Triton aluminum trailers for personal watercraft. These are $1500+ trailers, but many watercraft dealers end up with bookoos of them which they can't sell. I paid about $500 for each of them. They're fully aluminum, torsion axles, light yet very tough. Best trailers I've ever owned. |
|
| Author: | Whizzer [ Thu Dec 08, 2011 9:36 am ] |
| Post subject: | Re: trailers |
I am adapting a 2nd hand jet ski trailer for my TI. Can anyone tell me where to position the TI trailer cradles? |
|
| Author: | mmiller [ Thu Dec 08, 2011 10:09 am ] |
| Post subject: | Re: trailers |
67" spacing. Aft cradle sits at the forward edge of the aft side handle. |
|
| Author: | Outrider [ Fri Dec 09, 2011 1:56 pm ] |
| Post subject: | Re: trailers |
I have the Malone Sport trailer with TI cradles front and back. Can you guys tell me if it is ok to store the boat on its hull on the trailer indoors? Will it warp the hull? |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|