Hi all, wondering if anyone has fitted Railblazer rod holders to a TI, I have purchased a set and have found there doesn't seem to be a lot of options as there are not a lot of areas wide enough to accommodate them.Any feed back would be great
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Railblazer rod holders, anyone fitted them? http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=43177 |
Page 1 of 1 |
| Author: | romenfree [ Thu Jun 07, 2012 2:02 am ] |
| Post subject: | Railblazer rod holders, anyone fitted them? |
| Hi all, wondering if anyone has fitted Railblazer rod holders to a TI, I have purchased a set and have found there doesn't seem to be a lot of options as there are not a lot of areas wide enough to accommodate them. Any feed back would be great
|
|
| Author: | Snakebite1969 [ Thu Jun 07, 2012 2:54 am ] |
| Post subject: | Re: Railblazer rod holders, anyone fitted them? |
There should be heaps of room, check out the following thread for some info on where to put rod holders, in particular watch the Blaze your Hobie Tandem Islander video. http://www.hobiecat.com/forums/viewtopic.php?f=69&t=40535 and this video http://www.youtube.com/watch?v=ZQ3K8QTarDg&feature=player_embedded I'm currently trying to find room to fit the RailBlazer Fillet Table and hence chuck most of the fish waste away while at sea.  
|
|
| Author: | NOHUHU [ Thu Jun 07, 2012 10:57 am ] |
| Post subject: | Re: Railblazer rod holders, anyone fitted them? |
Rats! Snake just previewed my new blaza "rumble seat". 
|
|
| Author: | tonystott [ Thu Jun 07, 2012 11:16 am ] |
| Post subject: | Re: Railblazer rod holders, anyone fitted them? |
I thought it was a rear spoiler! LOL |
|
| Author: | romenfree [ Fri Jun 08, 2012 1:02 am ] |
| Post subject: | Re: Railblazer rod holders, anyone fitted them? |
excellent, thanks for the links. Nice work, do like the spoiler 
|
|
| Author: | Thrashie [ Fri Jun 08, 2012 9:13 pm ] |
| Post subject: | Re: Railblazer rod holders, anyone fitted them? |
put one on the other side and use em as flaps...once u start rising out of the water with a good wind, lift the rudder, and use it as a..uh....rudder! 
|
|
| Author: | NOHUHU [ Fri Jun 08, 2012 9:27 pm ] |
| Post subject: | Re: Railblazer rod holders, anyone fitted them? |
Mount them upside down and you have our elusive "hydrofoil". |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|