| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 2013 TI scupper diameter - heads up http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=50221 |
Page 1 of 1 |
| Author: | tonystott [ Sat Jan 18, 2014 4:22 am ] |
| Post subject: | 2013 TI scupper diameter - heads up |
Today I offered a friend a section of glassfibre painter pole, with a vertical split to allow it to be squeezed into the scupper as a bearing for an emergency rudder. On my 2012, it is a perfect squeeze fit, but on the rear scupper of a 2013, it "didn't touch the sides". Obviously Hobie has changed the molds to allow lining the forward scupper for strength when on a trolley, but the rears, while also enlarged, do not have the lining. Anyone building an emergency rudder using the scupper should be aware of the different diameters. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|