Hobie Forums
http://www.hobie.com/au/en/forums/

Hole spacing on TI trailer cradles
http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=53876		 Page 1 of 1
Author:  robbjd [ Fri Feb 06, 2015 2:52 pm ]
Post subject:  Hole spacing on TI trailer cradles
Matt, could you post the mounting hole spacing dimensions for the TI cradles?

Thanks, John
Author:  Buckaroo [ Sun Feb 08, 2015 10:51 am ]
Post subject:  Re: Hole spacing on TI trailer cradles
John, I just happen to have one lying around. From the center hole mine measures 19 13/16 to the left and 19 15/16 to the right hole. That is with it sitting flat on a table. The holes are 3/8". I wouldn't pre drill anything to these dimensions, there may be some variation as you can see from the difference on my cradle. I thought 3/8" was a bit large for the mounting bolts and put a plastic tubing bushing in the holes to reduce to 1/4" for my TI cart and also used fender washers to spread the load on the plastic.
- Chris
Author:  mmiller [ Mon Feb 09, 2015 3:50 pm ]
Post subject:  Re: Hole spacing on TI trailer cradles
Only spec I have is spacing between cradles. 67"
Author:  robbjd [ Mon Feb 09, 2015 5:02 pm ]
Post subject:  Re: Hole spacing on TI trailer cradles
Thanks for the info Chris. I've purchased a 2015 Tandem Island and want to outfit a trailer prior to delivery.
John
Author:  srcboating [ Wed Feb 11, 2015 10:38 pm ]
Post subject:  Re: Hole spacing on TI trailer cradles
mmiller wrote:
Only spec I have is spacing between cradles. 67"

Mike, was that 67" from back edge of forward cradle to front edge of rear cradle, or center line to center line?


Sent from my iPad using Tapatalk
Author:  mmiller [ Thu Feb 12, 2015 8:53 am ]
Post subject:  Re: Hole spacing on TI trailer cradles
On center.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/