I bought a demo 2017 Adventure Island and notice the daggerboard extends past the bottom of the hull (3/8" at the deepest point). I would like to trim the daggerboard so it is flush with the hull. Should I trim it or leave it as is?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Cut/Trim AI Daggerboard? http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=65348 |
Page 1 of 1 |
| Author: | dangalang [ Thu Aug 08, 2019 11:37 am ] |
| Post subject: | Cut/Trim AI Daggerboard? |
I bought a demo 2017 Adventure Island and notice the daggerboard extends past the bottom of the hull (3/8" at the deepest point). I would like to trim the daggerboard so it is flush with the hull. Should I trim it or leave it as is?
|
|
| Author: | tonystott [ Thu Aug 08, 2019 2:07 pm ] |
| Post subject: | Re: Cut/Trim AI Daggerboard? |
Why trim it? I don't see any harm that this tiny protrusion could cause. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|