Return to Hobie.com
Hobie Forums
It is currently Tue Apr 13, 2021 4:16 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sun Jul 19, 2020 12:35 pm 
Offline
Site Rank - Deck Hand

Joined: Thu Jul 11, 2019 10:42 am
Posts: 5
So, I bought a 2013 TI with a bad mast. Long story, but I ended up replacing it with a new one from the factory. After 3 months of EXCELLENT sailing, it suddenly won’t lock into the mast receiver. I saw a thread where someone mentioned there may be insufficient epoxy to hold the furling sheet spool in place. Bottom line: had to take the sail down and peddle home from a couple miles out. Great workout!

Need help: the lip of the ring that locks into the receiver is 9.5”. It is actually blocking a small part of the Hobie logo on the bottom of the lightning-rod warning on the mast.

If this is an excursion due to insufficient epoxy, how do I fix it?

Thanks in advance, as always.

JJ

_________________
2013 Tandem Island "Lilly Grace"
Of course it's red. Jeez.


Top
 Profile  
 
PostPosted: Mon Jul 20, 2020 5:13 am 
Offline
Site Rank - Captain

Joined: Mon Apr 10, 2017 5:06 am
Posts: 42
I'm not sure if this helps, but I just repaired a TI mast that was snapped 1/2 right under the furling drum. My local West Marine reccommended an Epoxy that goes into a midsized applicator gun. It was a two part that auto mixes with a "tip mixer." It was a white tube with Blue lettering- probably 12-14inches long. I then purchased a ~3-4ft Carbon fiber tube off eBay that perfectly fit the ID of the Hobie mast.

Overall, it was extremely easy to use & bonded the carbon fiber well.

In my opinion, the hard part for you will be removing the furling drum (if it doesn't easily move) and when re epoxy'ing - placing it in just the correct spot. I was left with about 2mm extra height after I bonded the mast. That was enough for the locking mechanism to not work. Luckily I found some nylon washers that I placed under the 3 screws on the mast receiver and now it works.

My local dealer does this sort of thing- you may want to reach out to a dealer and see if they want to tackle it first.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
cron
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group