| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| help conceptualizing mast ring repair on 2010 AI http://www.hobie.com/au/en/forums/viewtopic.php?f=71&t=70090 |
Page 1 of 1 |
| Author: | timo [ Tue Jul 26, 2022 9:13 am ] |
| Post subject: | help conceptualizing mast ring repair on 2010 AI |
The other day I noticed that my AI's mast was loose in the mast receiver on the front deck of the AI. Eventually it became apparent that there is a ring that is supposed to be secure a few inches up the mast from its base but that that ring has become unseated and is now a few inches higher up than it should be. This keeps the mast from being clipped in place when it is seated so it wobbles and moves about insecurely. I haven't been able to theorize how the ring was forced up the mast but, at any rate, it needs to be returned to its normal position and I suppose it should be glued in. I was wondering if any one has attempted this repair and if so, before I make this situation worse through inexperience, might have any advice about how to do this repair correctly. Many thanks! Tim |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|