| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Hobie Welder http://www.hobie.com/au/en/forums/viewtopic.php?f=72&t=67446 |
Page 1 of 1 |
| Author: | mbknubi [ Sat Sep 26, 2020 2:50 pm ] |
| Post subject: | Hobie Welder |
I am current using the welder to repair a large fork truck "ding/hole/crack". After using a heat gun to align the damaged sections in the hull as close as I could get them and creating the best "V" I could. I filled the crack as best as I could. I realize this may be an iterative process. The tool works well but there is a residual on the tip. What's the best way to clean the welding tip? Nubi |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|