Has anyone put a TI or AI on one of these?
| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| TI on a Yakima EasyRider trailer http://www.hobie.com/au/en/forums/viewtopic.php?f=73&t=66687 |
Page 1 of 1 |
| Author: | Polychrest [ Wed Jun 10, 2020 1:52 pm ] |
| Post subject: | TI on a Yakima EasyRider trailer |
Has anyone put a TI or AI on one of these?
|
|
| Author: | Tom Kirkman [ Wed Jun 10, 2020 1:55 pm ] |
| Post subject: | Re: TI on a Yakima EasyRider trailer |
Have not but it should be possible with some modifications. Might be a good trailer for the Island boats since I suppose it is lightly sprung. ....... |
|
| Author: | tomcfitz [ Thu Jun 11, 2020 11:46 am ] |
| Post subject: | Re: TI on a Yakima EasyRider trailer |
We have a single-level Yakima trailer, the "Rack and roll" and it holds two AIs with no issues. I imagine that one would hold a TI easily. Might be nice to have the lower level to hold gear and stuff! |
|
| Author: | Polychrest [ Fri Jun 12, 2020 9:15 am ] |
| Post subject: | Re: TI on a Yakima EasyRider trailer |
Yakima trailers do look like a smooth ride. I'm thinking a TI on the bottom, Outback on top and a skybox for storage. |
|
| Author: | PassWind [ Wed Jun 17, 2020 8:31 am ] |
| Post subject: | Re: TI on a Yakima EasyRider trailer |
I do not think the wheels/bearings are rated for water submersion |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|