| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| V-Brace Maintenance http://www.hobie.com/au/en/forums/viewtopic.php?f=75&t=10634 |
Page 1 of 1 |
| Author: | ren758 [ Fri Sep 05, 2008 6:37 am ] |
| Post subject: | V-Brace Maintenance |
Hey All, Just wondering how tight the V-brace under the sail should be. I'm not getting any deflection, but I don't want a problem either... Any suggestions? |
|
| Author: | gwiz [ Fri Sep 05, 2008 1:09 pm ] |
| Post subject: | |
When your mast no longer catches, or catches but won't reach its seat fully, you need to adjust it so that it will. gwiz |
|
| Author: | Tom Ray [ Sun Sep 07, 2008 5:31 am ] |
| Post subject: | |
Or, on the other end, when your mast goes down too far and rests on the upper bearing housing, you need to adjust the V-brace so that the mast is lifted clear. If you go too far, you will raise it above the catch, as gwiz says. I coated mine with Boeshield T-9 to protect against corrosion. Two or more different metals plus salt water can never be good. 
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|