| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mirage drive shaft too long on one side/ http://www.hobie.com/au/en/forums/viewtopic.php?f=75&t=48785 |
Page 1 of 1 |
| Author: | rubear [ Mon Aug 05, 2013 1:38 pm ] |
| Post subject: | Mirage drive shaft too long on one side/ |
We purchased a Hobie Kayak with Mirage drive. We purchased a 2nd last month. The Mirage drive that came with our 1st purchase works fine. But the second Mirage drive does not easily lock in place. I measured the two metal shaft dimensions. For the unit that inserts easily, I measured 16.8mm beyond the plastic on both sides On the troublesome unit, I measured 16.8mm on one side & 17.8mm on the other. I wouldn’t think that 1mm would be enough, but it appears to be. Suggestions? Thank you, -Robert |
|
| Author: | bjb [ Mon Aug 05, 2013 3:20 pm ] |
| Post subject: | Re: Mirage drive shaft too long on one side/ |
Try tapping the longer end of the shaft with a hammer to even them out, see if that helps. |
|
| Author: | rubear [ Mon Aug 05, 2013 3:54 pm ] |
| Post subject: | Re: Mirage drive shaft too long on one side/ |
bjb wrote: Try tapping the longer end of the shaft with a hammer to even them out, see if that helps. Thanks, I wondered if that was OK. -Robert |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|