| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Thread marks in hull around scupper tube inserts http://www.hobie.com/au/en/forums/viewtopic.php?f=75&t=52571 |
Page 1 of 1 |
| Author: | siravingmon [ Sat Aug 16, 2014 12:48 pm ] |
| Post subject: | Thread marks in hull around scupper tube inserts |
I was about to add some masking tape to the hull around the scuppers to create a venturi to help drainage (following Roadrunner's excellent suggestion) when I noticed these thread marks in the hull around the scupper tube inserts in my new AI. They're much more pronounced on the port side. This is normal, right?  
|
|
| Author: | tonystott [ Sat Aug 16, 2014 5:24 pm ] |
| Post subject: | Re: Thread marks in hull around scupper tube inserts |
I would say yes, normal. |
|
| Author: | siravingmon [ Sun Aug 17, 2014 9:51 am ] |
| Post subject: | Re: Thread marks in hull around scupper tube inserts |
Thanks Tony, I thought as much... |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|