| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| TI Hull Seperating at RotoMold Joint http://www.hobie.com/au/en/forums/viewtopic.php?f=75&t=53304 |
Page 1 of 1 |
| Author: | Clintvava [ Fri Nov 07, 2014 4:18 pm ] |
| Post subject: | TI Hull Seperating at RotoMold Joint |
https://www.flickr.com/photos/a8cmg/15549577158/ https://www.flickr.com/photos/a8cmg/15115066724/ I have a pronounced edge on the seam of the hull. What the heck is going on? When I run my finger along the seem I can feel an edge. Is the hull loosing its seal? I just noticed it today. This is a 2012 hull The warranty expired in February  Is this something the plastic welder can fix, or is this the beginnings of a more pronounced hull issue. |
|
| Author: | Jbernier [ Fri Nov 07, 2014 5:18 pm ] |
| Post subject: | Re: TI Hull Seperating at RotoMold Joint |
The two halves the mold don't always line up perfect - sometimes you have a step along the edge in areas - that looks normal. It isn't two pieces - it's one solid part of plastic (look inside and you'll see what I'm saying. The outside gets trimmed by hand, and they all vary. |
|
| Author: | Clintvava [ Fri Nov 07, 2014 10:40 pm ] |
| Post subject: | Re: TI Hull Seperating at RotoMold Joint |
Thank you for responding. I see you work for HOBIE. It is unusual cause I never noticed these before. I will take your advice and peek inside. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|