| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| 2020 TI bearing plate/mast receiver reassembly help http://www.hobie.com/au/en/forums/viewtopic.php?f=75&t=68001 |
Page 1 of 1 |
| Author: | Noah_north [ Fri Mar 12, 2021 10:23 am ] |
| Post subject: | 2020 TI bearing plate/mast receiver reassembly help |
Hi all! I'm sure this information already exists on the forum, but have been unable to find the info i need by searching, as im probably using the wrong parts terminology. I disassembled the bearing cups/plate to reinstall the delrin bearings. I am now remounting and cant seem to figure out the orientation of the plastic guard that is a part of the bearing plate. is there a schematic of these parts/install? or if anyone has a closeup photo of how it looks assembled with the guard, that could be very helpful. thanks so much, Noah |
|
| Author: | mmiller [ Fri Mar 12, 2021 11:30 am ] |
| Post subject: | Re: 2020 TI bearing plate/mast receiver reassembly help |
https://media.hobie.com/item_attachments/79512101.pdf |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|