Return to Hobie.com
Hobie Forums
It is currently Fri Mar 29, 2024 6:55 am

All times are UTC - 8 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
PostPosted: Sun Jul 15, 2007 5:52 pm 
Offline
Site Rank - Captain

Joined: Tue Jun 12, 2007 5:00 am
Posts: 66
Location: Jupiter Florida
I was peddling when peddle pressure dropped in half and I slowed down. I pulled the drive a found that one fin was coming lose from the drive. The post(rod) with notches was coming out. I pushed it back in. It seemed fixed but after a few minutes it came out again. Anyone have any suggestions? :shock: :shock: :oops:


Top
 Profile  
 
 Post subject:
PostPosted: Sun Jul 15, 2007 10:33 pm 
Offline
Hobie Approved Guru

Joined: Sat Nov 12, 2005 10:46 pm
Posts: 3017
Location: Escondido
Most likely one (or both) of two things: 1) your mast retaining screw has backed out enough to allow the mast to slip out or 2) your mast hole (part of your sprocket) has widened under use and needs to be replaced.

In any event, either of these conditions can be observed and corrected before failing by including them in your daily drive inspection. Here's a link to an inspection check list:
http://www.hobiecat.com/community/viewtopic.php?t=6418
8)


Top
 Profile  
 
PostPosted: Sat Sep 05, 2020 12:28 pm 
Offline
Site Rank - Deck Hand

Joined: Sat Sep 05, 2020 10:34 am
Posts: 1
Has anyone replied to the front n coming loose? It’s the same problem I have


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC - 8 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Jump to:  
© Hobie Cat Company. All rights reserved.
Powered by phpBB® Forum Software © phpBB Group