Hobie Forums
http://www.hobie.com/au/en/forums/

drill size.
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=25122		 Page 1 of 1
Author:  fjarhead [ Mon May 24, 2010 12:49 pm ]
Post subject:  drill size.
I am trying to install my anchor trolley and i need to know what is the size of the drill bit to use.
Author:  RPB [ Tue May 25, 2010 6:11 am ]
Post subject:  Re: drill size.
I made my own trolley, all I can say is to use a drillbit SMALLER than the bolt that will be going through it. I dab silicone seal on after drilling the small hole, then thread/screw the Stainless bolt through the guide hole, dab a bit of silicone inside, then attach the Stainless washer and nut. The Silicone acts as a bit of lubricant and a thread sealer too.
Author:  Lat22 [ Wed May 26, 2010 8:22 am ]
Post subject:  Re: drill size.
I installed mine last night and as far as I can tell, it came out good. The drill bits I used (along with my notes) are at home so I'm not going to try to remember what I used. If I remember, I'll post up when I go home for lunch. It's scary drilling holes in these beautiful boats. :mrgreen:
Author:  fjarhead [ Fri Jul 02, 2010 7:34 am ]
Post subject:  Re: drill size.
:) thanks for the post, i have installed anchor trolley and it works fine......
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/