Hobie Forums
http://www.hobie.com/au/en/forums/

Accessory plug on the front of the PA
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=36617		 Page 1 of 1
Author:  Xi Bowhunter [ Thu Jul 07, 2011 7:35 am ]
Post subject:  Accessory plug on the front of the PA
What size pole or pipe fits into the accessory plug on the front of the PA? I think it is for an optional sail, but I'm not sure.

I want to make a camera/camcorder mount and use that accessory plug.
Author:  Tom Kirkman [ Thu Jul 07, 2011 8:31 am ]
Post subject:  Re: Accessory plug on the front of the PA
It's for the sail mast. I takes a 1-inch OD fitting.

I used the same opening on my Outback for the fish finder mount. Get some PVC and go straight up, then fit a 45-degree turn and more straight PVC to get the unit as high and as far back towards you as desirable. Just watch out that you don't locate it so far back that it hits the Mirage Drive.
Author:  Xi Bowhunter [ Thu Jul 07, 2011 8:40 am ]
Post subject:  Re: Accessory plug on the front of the PA
Tom Kirkman wrote:
It's for the sail mast. I takes a 1-inch OD fitting.

I used the same opening on my Outback for the fish finder mount. Get some PVC and go straight up, then fit a 45-degree turn and more straight PVC to get the unit as high and as far back towards you as desirable. Just watch out that you don't locate it so far back that it hits the Mirage Drive.



Thank you. That is exactly what I needed to know.
Author:  soulshaker [ Thu Jul 14, 2011 1:29 pm ]
Post subject:  Re: Accessory plug on the front of the PA
Xi Bowhunter wrote:
Tom Kirkman wrote:
It's for the sail mast. I takes a 1-inch OD fitting.

I used the same opening on my Outback for the fish finder mount. Get some PVC and go straight up, then fit a 45-degree turn and more straight PVC to get the unit as high and as far back towards you as desirable. Just watch out that you don't locate it so far back that it hits the Mirage Drive.



Thank you. That is exactly what I needed to know.


Bowhunter, have you seen these? Might save you the project time. Reasonable cost too:
http://shop.ebay.com/i.html?_from=R40&_trksid=p5197.m570.l1313&_nkw=hobie+camera+mount&_sacat=See-All-Categories
Author:  DouGR81 [ Sat Oct 15, 2011 8:52 pm ]
Post subject:  Re: Accessory plug on the front of the PA
Does the 1" OD fit snug?
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/