Hobie Forums
http://www.hobie.com/au/en/forums/

PA Cradles Question
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=40762		 Page 1 of 1
Author:  redgrappler [ Sun Jan 01, 2012 11:50 am ]
Post subject:  PA Cradles Question
I know you can bolt the PA cradles onto flat surfaces. At least that is what it looks like on some of the posts I have seen on this forum. On my truck I have a pair of Vantech racks that have a 600 lbs capacity. It uses the T-bolt style screws to install attachments. Are any of you using this to install your cradles to your racks or trailers?

http://vantech.us/pick_up/Special_edition/gen3_5_small.jpg
Author:  Bassmantrs [ Sun Jan 01, 2012 7:38 pm ]
Post subject:  Re: PA Cradles Question
Looks similar to a TracRac and they make kayak cradles, check out the accessories. Should run about $149.00

http://www.rackwarehouse.com/tracrac-44 ... rack.html#

Check around for dealers to see if their bolt system matches yours.
Author:  redgrappler [ Sun Jan 01, 2012 7:57 pm ]
Post subject:  Re: PA Cradles Question
Thank goodness for google :)

Image
Author:  atavuss [ Mon Jan 02, 2012 9:12 am ]
Post subject:  Re: PA Cradles Question
Red, do you have any more info on what was used under the cradles in the picture you posted? I need to mount Hobie's PA cradles to 3/4" pipe racks on my trailer.
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/