| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Truck rack for PA's http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=47605 |
Page 1 of 1 |
| Author: | salmontim [ Tue May 14, 2013 8:24 pm ] |
| Post subject: | Truck rack for PA's |
 Sent from my SCH-I510 using Tapatalk 2 I used PVC conduit to provide support for the hulls. The upper rack are made of 3" conduit cut to a 9ft lenght. I attached them to the after crossbar (above tail gate). The lower rack is made of 2" PVC conduit to allow more clearance for the lower YAK. All conduit pipes are spaced 10 inches on center. The methods I used was found on this forum using tequniques found on varrious trailer topics. |
|
| Author: | Elgeebee [ Wed May 15, 2013 3:30 am ] |
| Post subject: | Re: Truck rack for PA's |
Nice job! |
|
| Author: | CalicoJack [ Sat May 18, 2013 12:29 pm ] |
| Post subject: | Re: Truck rack for PA's |
Nice work! Please post a loaded up picture when you get time. I would love to see it. |
|
| Author: | Hobie Angler [ Sat May 18, 2013 2:45 pm ] |
| Post subject: | Re: Truck rack for PA's |
 great job...! Looks simple enough. That should make it easy to load and unload.
|
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|