Hobie Forums
http://www.hobie.com/au/en/forums/

Rectangular hatch insert - dimensions ?
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=47940		 Page 1 of 1
Author:  Scrumpy [ Sat Jun 08, 2013 12:06 pm ]
Post subject:  Rectangular hatch insert - dimensions ?
Hi, can anyone please provide me with the dimensions of the insert for the rectangular hatch?

I'm looking to fit the hatch to an Outback and wanted to know the size of the insert.

Cheers
Rob
Author:  Scrumpy [ Sun Jun 09, 2013 11:29 am ]
Post subject:  Re: Rectangular hatch insert - dimensions ?
Nobody purchased one ?
Author:  basskicker [ Mon Jun 10, 2013 7:16 am ]
Post subject:  Re: Rectangular hatch insert - dimensions ?
Are you looking for the dimensions of the drop in gear bucket? Just a little confused as to what you mean when you say "insert". :?:
Author:  Scrumpy [ Mon Jun 10, 2013 7:21 am ]
Post subject:  Re: Rectangular hatch insert - dimensions ?
basskicker wrote:
Are you looking for the dimensions of the drop in gear bucket? Just a little confused as to what you mean when you say "insert". :?:


Yup, that's the one!
Author:  basskicker [ Mon Jun 10, 2013 11:07 am ]
Post subject:  Re: Rectangular hatch insert - dimensions ?
As best I can measure, here ya go. 11 7/8" long, 8 1/8"wide, 4 3/4" deep. Length and width were taken ouside edge to outside edge at the top of the bucket and depth was measured from floor to top of outside edge. Hope it helps. :D .
Author:  Scrumpy [ Mon Jun 10, 2013 11:39 am ]
Post subject:  Re: Rectangular hatch insert - dimensions ?
basskicker wrote:
As best I can measure, here ya go. 11 7/8" long, 8 1/8"wide, 4 3/4" deep. Length and width were taken ouside edge to outside edge at the top of the bucket and depth was measured from floor to top of outside edge. Hope it helps. :D .


Cheers, much appreciated!
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/