Hobie Forums
http://www.hobie.com/au/en/forums/

What sz pvc fits rear scupper holes?
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=49743		 Page 1 of 1
Author:  Jude [ Tue Nov 05, 2013 1:37 pm ]
Post subject:  What sz pvc fits rear scupper holes?
Building downrigger platform... Will post pics when finished..
Author:  Jude [ Tue Nov 05, 2013 5:56 pm ]
Post subject:  Re: What sz pvc fits rear scupper holes?
3/4 fits perfect
Author:  Thinwater skinner [ Wed Nov 06, 2013 12:44 pm ]
Post subject:  Re: What sz pvc fits rear scupper holes?
Always remember the scupper holes are a very weak spot on the yak... Stress and strain in not good on the thin walled area. good luck
Author:  Jude [ Wed Nov 06, 2013 4:59 pm ]
Post subject:  What sz pvc fits rear scupper holes?
I hear ya. I figure if it can handle the weight of the yak on the cart it can handle a 5 pound downrigger. The weight will be on the platform feet. Scupper pvc is to hold in place...
Author:  captrich [ Sat May 23, 2015 9:04 pm ]
Post subject:  Re: What sz pvc fits rear scupper holes?
I see this is an old post. I'd really like to know how this worked out.
Author:  Jude [ Mon May 25, 2015 8:55 pm ]
Post subject:  Re: What sz pvc fits rear scupper holes?
Worked out awesome. I used dowels with rubber feet for the platform. The pvc in the scuppers just adds a little stability, not much i dont think. I drilled holes in the platforms above the scuppers and slid the pvc down into them, clips in the top of the pvc keep them from sliding through... Ill try post some pics soon as i know this is prob of interest to some. downrigger and platform are behind the seat i totally dig it


Sent from my iPhone using Tapatalk
Author:  Salsa [ Sun Jun 21, 2015 11:37 am ]
Post subject:  Re: What sz pvc fits rear scupper holes?
Whatever happened to these pics? Ha. Still like to check out your rig/project.
Thanks and get bent,
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/