Hobie Forums
http://www.hobie.com/au/en/forums/

Plug 'n Play Downrigger set-up (V2) - 2014 PA14
http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=50004		 Page 1 of 1
Author:  joeyb [ Mon Dec 09, 2013 8:07 am ]
Post subject:  Plug 'n Play Downrigger set-up (V2) - 2014 PA14
Was asked for some info on this set-up...so thought I would share it here.

Downrigger set up on my 2014 PA14.

- Frame made with 3/4” PVC.
- Arrows indicate, (2) 1/2” foam rubber gaskets (from an old bicycle handlebar)
- Nylon 1” strap with plastic clip/buckle.
- (4) Bolts, washers and wingnuts.
Image
There is foam rubber glued to the underside of board (where it contacts PA hull)
Image
PVC sits on rubber rest:
Image

Image
1" adjustable strap goes around bottom seat rail:
Image

Image
set-up below is used for trolling planer floats (off sides) and a regular float down the middle.
Image
Rigged 'n Ready (just add water)
Image

Link to the 2010 PA version:
viewtopic.php?f=78&t=47241


Regards, JoeyB
Author:  badbill [ Wed Dec 11, 2013 5:27 am ]
Post subject:  Re: Plug 'n Play Downrigger set-up (V2) - 2014 PA14
Thank you!


Sent from my iPad using Tapatalk
Author:  badbill [ Thu Dec 12, 2013 5:57 pm ]
Post subject:  Re: Plug 'n Play Downrigger set-up (V2) - 2014 PA14
Joey are you a Hardcore guy? I noticed Stew Rat took a picture in your video.


Sent from my iPad using Tapatalk
Author:  joeyb [ Sat Dec 14, 2013 7:18 pm ]
Post subject:  Re: Plug 'n Play Downrigger set-up (V2) - 2014 PA14
badbill wrote:
Joey are you a Hardcore guy? I noticed Stew Rat took a picture in your video.


Sent from my iPad using Tapatalk


I have fished the Hardcore Invitational on the Catawba and some Carolina Yakfish tourney's with Stew-Rat.
Author:  Salmax [ Sat Dec 21, 2013 4:12 pm ]
Post subject:  Re: Plug 'n Play Downrigger set-up (V2) - 2014 PA14
love the set-up....fantastic job
Page 1 of 1 All times are UTC - 8 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
http://www.phpbb.com/