| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| PA14 Hatch Sealing http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=52319 |
Page 1 of 1 |
| Author: | kayakdannj [ Mon Jul 28, 2014 7:09 am ] |
| Post subject: | PA14 Hatch Sealing |
How do you guys seal your front hatch better on a PA14. I get a little water in the hull and in the liner from boat wakes and rain. The liner does not fit in the hatch right and leaves a gap in each rear corner. |
|
| Author: | Jude [ Tue Jul 29, 2014 1:15 am ] |
| Post subject: | Re: PA14 Hatch Sealing |
Addressed many times. Search it in this forum most people upgrade the seal to a bigger rubber |
|
| Author: | kayakdannj [ Tue Jul 29, 2014 3:38 pm ] |
| Post subject: | Re: PA14 Hatch Sealing |
I searched found one that was for the older models and it went off topic a page in. Just wondering if there was a more recent post. |
|
| Author: | FishnYaks [ Sat Sep 13, 2014 3:26 pm ] |
| Post subject: | Re: PA14 Hatch Sealing |
https://www.youtube.com/watch?v=1epb7IZhnyE Here is how we did it. Some 1/2 polyethylene foam, spray glue and Voila, it's sealed. The extra thickness of the foam compresses the tub deeper in to the weather strip AND insulates the tub. We then went even further and insulated the tub itself. It makes a pretty good cooler and I'm in Florida sun! See that here: https://www.youtube.com/watch?v=K9RCZNrchbw Hope it helps! |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|