| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| Mirage drive changes ? http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=53066 |
Page 1 of 1 |
| Author: | mrfixit1 [ Sun Oct 05, 2014 7:25 pm ] |
| Post subject: | Mirage drive changes ? |
I recently got a new Pa 14 my question is about the Mirage drive are all drives interchangeable . I have some early stainless steel drives pre 2005 . Can I put turbo fins on this drive? The shafts are not screw in or installed with a allen screw they appear to be held in with cotter pins .Can I use turbo fins and new shafts on this drive if I drill shafts to accept cotter pins ? Will this drive work on a 2014 hull ? How reliable were the old drives ? |
|
| Author: | mmiller [ Mon Oct 06, 2014 3:26 pm ] |
| Post subject: | Re: Mirage drive changes ? |
Get Turbo kit 72065 to fit the original stainless steel sprockets. The masts are drilled for and include cotter keys. Old drives need a new drum shaft to work with Click and Go hulls. The original shafts can spin in the spine and cause the levers to trip open. |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|