| Hobie Forums http://www.hobie.com/au/en/forums/ |
|
| need some help http://www.hobie.com/au/en/forums/viewtopic.php?f=78&t=53334 |
Page 1 of 1 |
| Author: | yakingduck [ Tue Nov 11, 2014 7:12 pm ] |
| Post subject: | need some help |
I was out fishing sunday and one of the mast for the fins broke off it was my fault its been bent a few times i tryed an easy out and it wont even turn need some ideas any help would be great i have a 2014 pa14 |
|
| Author: | mmiller [ Tue Nov 11, 2014 7:31 pm ] |
| Post subject: | Re: need some help |
Maybe just replace the sprocket and mast rather than struggle with it. The sprockets aren't too expensive ($18.99 USD / USA 11-2014) |
|
| Author: | yakingduck [ Tue Nov 11, 2014 7:39 pm ] |
| Post subject: | Re: need some help |
Thanks i was thinking the same thing but i had to try Is that price for the mast and sprocket |
|
| Author: | redsinthehead [ Wed Nov 12, 2014 6:49 am ] |
| Post subject: | Re: need some help |
Do you have enough to get a grip on? Try a little heat... NOT a torch, blow drier, heat gun... |
|
| Author: | yakingduck [ Wed Nov 12, 2014 8:23 am ] |
| Post subject: | Re: need some help |
I dont have enough to grip i might try a soldering iron in the hole i got driled in it be for i give up |
|
| Author: | brianBFD [ Wed Nov 12, 2014 8:47 am ] |
| Post subject: | Re: need some help |
I had to do this same repair a month ago and ended up doing this. A lot less hassle. mmiller wrote: Maybe just replace the sprocket and mast rather than struggle with it. The sprockets aren't too expensive ($18.99 USD / USA 11-2014)
|
|
| Author: | mmiller [ Wed Nov 12, 2014 9:12 am ] |
| Post subject: | Re: need some help |
That is just the sprocket. |
|
| Author: | redsinthehead [ Wed Nov 12, 2014 9:23 am ] |
| Post subject: | Re: need some help |
solder not strong enough to hold... will the EZ out bite? |
|
| Author: | yakingduck [ Wed Nov 12, 2014 11:03 am ] |
| Post subject: | Re: need some help |
Thanks for the help im just going to replace the sprocket i was just trying to keep from takeing the drive apart And no the easy out kept slipping when i put some good pull on it its a very good set i have there from snap on tools |
|
| Page 1 of 1 | All times are UTC - 8 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|